diablo175 Posted December 7, 2017 Share Posted December 7, 2017 Josh has very kindly and patiently been working with me to develop his Mongoose pickups. The first(?) iteration went into my Swirled Cali and sounds killer but I had wanted a little more mid range bark and low end articulation. Josh took the challenge and has sent along 3 new ones (along with some cool swag!) 2 of which are the same model but he included some extra pole screws in 1018 and 1022: the type/grade of steel used makes a big difference. By including extras, I can run them in and out and tweak the tone considerably. The third, as I understand it, is similar to his Cobra wind but with a slug row and roughcast A4 magnet. All are at about 14.2 (+/-) K output. I foresee a LOT of soldering in my near future... Link to comment Share on other sites More sharing options...
bubs_42 Posted December 7, 2017 Share Posted December 7, 2017 Loving the Swag! A set of Josh's Humbuckers may be needed soon. Link to comment Share on other sites More sharing options...
aknapp Posted December 8, 2017 Share Posted December 8, 2017 Cool logo - great pickups. Link to comment Share on other sites More sharing options...
Sugartune Posted December 9, 2017 Share Posted December 9, 2017 Wicked! Love the shirt, too. Link to comment Share on other sites More sharing options...
Michael_B Posted December 11, 2017 Share Posted December 11, 2017 On 12/7/2017 at 11:57 AM, diablo175 said: Josh has very kindly and patiently been working with me to develop his Mongoose pickups. The first(?) iteration went into my Swirled Cali and sounds killer but I had wanted a little more mid range bark and low end articulation. Josh took the challenge and has sent along 3 new ones (along with some cool swag!) 2 of which are the same model but he included some extra pole screws in 1018 and 1022: the type/grade of steel used makes a big difference. By including extras, I can run them in and out and tweak the tone considerably. The third, as I understand it, is similar to his Cobra wind but with a slug row and roughcast A4 magnet. All are at about 14.2 (+/-) K output. I foresee a LOT of soldering in my near future... On my Strats, I've installed common shielded wire connectors at the wire-ends, so that I'd have solderless pick-up swapping. I haven't noticed any difference in sound. Is there a good reason not to do that? Link to comment Share on other sites More sharing options...
diablo175 Posted December 11, 2017 Author Share Posted December 11, 2017 6 hours ago, Michael_B said: On my Strats, I've installed common shielded wire connectors at the wire-ends, so that I'd have solderless pick-up swapping. I haven't noticed any difference in sound. Is there a good reason not to do that? Prolly not. Except that I've spent the last couple of years developing and honing my soldering skills to the point where I can do it in around a half hour... just seems a shame to not use it after taking the time to hone them. LOL Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.