Jump to content
Hamer Fan Club Message Center

Leaderboard

Popular Content

Showing content with the highest reputation on 04/05/2022 in all areas

  1. The biggest part of the reason the HFC has been the best damn forum on the internet for 25 years is because of the quality of its members as well as the mods. We also don't trust algorithms completely to validate that those registering actually are people! As such, the mods spend a good amount of time manually reviewing registrations. There are often cases where the registration looked fishy due to ip location, username, email address or muck rakers trying to access via second accounts. If you feel that your registration validation is taking too long, feel to reach out via the Contact Us link at the bottom of the page. Let us know who you are, your username, what email you used to register, and what brought you to the HFC and we'll take a look.
    6 points
  2. No golden buzzer for you, K.
    1 point
  3. Anyway, where were we? Prices can be "adjusted" in some cases. Cases will be provided in most cases. Just in case you need a reminder of what's available. 2019 Custom Shop '59 Stratocaster Fackyo MELOCASTER 2015 Fackyo SCHARTER 2012 Fackyo II STRATOBIRD 2003 Hamer Monaco SuperPro 2004 Hamer Monaco 2001 Gibson Les Paul Custom In some cases, cases will be chosen on a case-by-case basis.
    1 point
  4. Keep On Truckin' - Eddie Kendricks
    1 point
  5. Thanks. Yep, that's pretty much the process. This is the second time that I've done this, but essentially you have to plan for the back layer to be a good thickness for a cover plate. I could have gone a little thicker for sure. Here is how I went about it. I scored around the template very carefully. Then I scored an area on the straight side extra deep until I could push a knife through. I put that on the scroll saw where I could thread a blade through the slot and very carefully cut on the line. That's the rear plate before gluing to the body wing. Gluing the rear plate to the treble side wing. The top face is up here. I used alignment pins between the rear layer and the wing core to keep the plate perfectly in place. I also glued the rear plate with hot hide glue so it would be simple to clean up the squeeze out. Just like magic.
    1 point
  6. And more progress! Yippee!!!
    1 point
×
×
  • Create New...