Jump to content
Hamer Fan Club Message Center

Truss rod nut replacement - Vintage Hamer


Recommended Posts

I need to replace the truss rod nut on my Hamer Vector from 1984, which is rusty/stripped. Is this the correct one?

http://www.stewmac.com/Hardware_and_Parts/Nuts_and_Washers/Truss_Rod_Nuts_for_Gibson_-_6_Pack.html

If this is correct, I wasn't sure if I should get the short or long taper.

There's also this one on Ebay: http://www.ebay.com/itm/NEW-Brass-Truss-Rod-Nut-10-32-thread-Fits-GIBSON-Guitar-Bass-Made-in-USA-/191908751457?epid=1221898430&hash=item2caea72861:g:l4kAAOSwaB5Xk3n7

I'm assuming all I need to do is unscrew the old one (there's still some threads left) and place the new one, correct? Hopefully I won't screw it up... Any suggestions will be appreciated.

 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...