FS Duotone practice amp

butcher

Active member
Supporter
5 Marshall Artist 3203, 2 black , 3 red. 30w heads.

5 Marshall 1965A cabs, 2 black, 3 red.  4x10

5 Marshall 1965B cabs, 4 black, 1 red. 4x10

3 Marshall 1966B cabs,  1black, 2 red. 2x12

2 marshall 1965B cabs converted to 1x15 ported plus horn.

Center row powered by a Carvin DCM1000 power amp, small Mackie 8ch mixer.

$7500.00

For $.50 a mile, I will deliver and set it up for you.

stax3.jpg

 
“Mo’ Amps, mo’ Better” - Butcher. 
 

This was an original quote by Butcher damn near some 30 years ago. 
 

“DuoTone Practice Amp” - Classic 

😳🤣

GLWTS! 

Hamerica

 
Last edited by a moderator:
I've owned a couple of 1965B cabs before, if you're looking for a cab that's lightweight and tote-able that's made to '80's JCM800 standards (no particle board), I'd definitely recommend them.  The original 80's Celestion 10" speakers didn't do much for me, but there's no shortage of 10" speaker varieties to replace them with nowadays...besides, somebody out there might like the originals. 

When shopping for the old 1965B cabs, I rarely if ever encountered the 2x12' equivalent 1966 model.   Does anybody know if they have a following like the Model 1965 cabs?

 
The sound of god right there folks. Incredible. Too bad I'm in a retirement home and with terrible hearing.

 
Last edited by a moderator:
I like that there's a speaker mounted to the ceiling so you can jam along with your favorite recorded tunes.

One of the few pro players I've know, Paul Jackson of Bloodgood (not the more well known Jr), preferred the 4x10, he said it cut through the mix better than the 4x12.

 
I’m still waiting for the two center stacks to swing open and see Rob Halford emerge on the Harley.

 
I mowed lawns and ran 2 newspaper routes all Summer trying to save up enough to buy that setup.

I almost have it covered. With luck, and we get a lot of snow to shovel, I should have enough by Spring.

But it will take a couple more years before I have enough for delivery fees.

 
Amazeballs! 
Serious question: How do you get signal from one guitar to your 5 heads? TIA
I built myself a 5 way splitter with jfets. Before that I would run a stereo out delay into two stereo out chorus pedals and then one side of one of the chorus pedals to a stereo out reverb pedal giving me three chorus outs and two reverb outs.

 
Interesting! That’s a great way to get that done with chorus and reverb pedals.

Could you please tell us more about the splitter? What is the design and did you do the build? Tia!

 
I tried to find the schematic I used , but no luck. I put this together about six years ago. As you can see in the pictures,I had to use surface mount Jfets, because at the time I couldn't find the transistor sized ones. A real pain in the ass.

20241219_175302.jpg

20241219_175000.jpg

20241219_174942.jpg

 
Back
Top