Jackson RR1?
- Thread starter hamerhead
- Start date
Looks like an RR1T, though if this was built pre-fender, they may have all been RR1s with Floyds or not. Serial number at the end of the fret board can tell you when it was built. I think it is likely pre-Fender because I think they only made that Lighting Graphic from the late 80s through the late 90s.
Usually a JB in the bridge and a Jazz in the neck. I've wanted a USA RR1 forever, but they are just too damn expensive now, so I settled for an MJ series RRT. At least the new MJ series feels more like a USA Jackson than the older MIJ RR5s. I owned one of those too, and while nice, the fit and finish on mine is more like my USA Jackson. But I digress.
That's probably a factory air brush job, and a rarer one. If the ends aren't chipped up, it's probably worth well north of $2500, though it is hard to tell how much of what is getting asked for it is translating to getting. I see $4k a lot on Reverb.
Usually a JB in the bridge and a Jazz in the neck. I've wanted a USA RR1 forever, but they are just too damn expensive now, so I settled for an MJ series RRT. At least the new MJ series feels more like a USA Jackson than the older MIJ RR5s. I owned one of those too, and while nice, the fit and finish on mine is more like my USA Jackson. But I digress.
That's probably a factory air brush job, and a rarer one. If the ends aren't chipped up, it's probably worth well north of $2500, though it is hard to tell how much of what is getting asked for it is translating to getting. I see $4k a lot on Reverb.
Dave Scepter
Well-known member
