Speaking of Glue..

[bubs_42]

I have a 4x12 that has had a corner joint nocked loose during shipping. If I glue it back up it will be as good as new. Not one of those ugly smashed amp heads that i've seen on the board. I have clamps and its prepped I just need to know what glue to use.

[Jem]

Personally i'd use Titebond. I think epoxy or something simular will be too rigid if you get my drift.

[bubs_42]

Thank you.

[Moose]

Epoxy isn't necessarily more rigid than titebond in a properly glued joint. In some cases, it is less rigid, in fact.

Still, titebond should work just fine as long as you get good wood to wood contact and can clamp it properly. And it's probably the easiest to get and use.

[bubs_42]

Thanks Gentlemen, Titebond was the way I went and it worked perfectly.