I swapped out a standard sized SD Custom for a TB-5 one on the Python Cali and noticed the ring was slightly larger (for obvious reasons). This created a misalignment for the mounting ring screw holes and those on the body.
And while the TB p'up would squeeze into a std. sized ring, I finally opted for bending the TB-sized ring to match up w/ the screw holes. Thus far, I've yet to notice any issues resultant of the move other than slight gap between the ring and the body that is barely noticeable.
For those of you who have performed this mod, what did you do?
Question
diablo175
I swapped out a standard sized SD Custom for a TB-5 one on the Python Cali and noticed the ring was slightly larger (for obvious reasons). This created a misalignment for the mounting ring screw holes and those on the body.
And while the TB p'up would squeeze into a std. sized ring, I finally opted for bending the TB-sized ring to match up w/ the screw holes. Thus far, I've yet to notice any issues resultant of the move other than slight gap between the ring and the body that is barely noticeable.
For those of you who have performed this mod, what did you do?
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.