I think this has been asked before, but I can't find the question or answer. Apologies for being repetitive. I'm slowly making progress on my SSI project and need (want) to buy a new Floyd. I need to figure out the nut size. The nut on it appears to be the R2 - 1/58. But the actual neck width at the nut is closer to 1 11/16 like an R3 or R4. Any thoughts on the correct nut? Also, I just realized I need to measure for depth too and see if it is a R9 or R8. Any suggestions on where the height is measured?
Question
bcsride
Experts,
I think this has been asked before, but I can't find the question or answer. Apologies for being repetitive. I'm slowly making progress on my SSI project and need (want) to buy a new Floyd. I need to figure out the nut size. The nut on it appears to be the R2 - 1/58. But the actual neck width at the nut is closer to 1 11/16 like an R3 or R4. Any thoughts on the correct nut? Also, I just realized I need to measure for depth too and see if it is a R9 or R8. Any suggestions on where the height is measured?
3 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.